Skip to product information
P80 Volvo Shifter Cable End Bushing Retrofit+Upgrade Kits
$19.99
These bushings are designed to bridge the gap between shifter cables and transmission levers when retrofitting either 1) P2 M56LK or 2) P2 M66 transmissions into either A) -99 cabled or B) 00- cabled shifters/vehicles.
The ball end design provides an upgrade in shifting precision and responsiveness, replacing the pin over sloppy rubber bushing OE design.
See photos for compatible shift lever comparison.
Installation
- Clear a working area around your transmission lever(s).
- Unclip the shift cable end from the pin and pull up to remove.
- Remove the OEM bushing from the cable end. Be patient.
- Unbolt the pin on the lever.
- Bolt in the replacement ball end.
- Grease the ball with Super Lube PTFE grease or equivalent.
- Install the bushing bottom half overtop the ball end. Warming it up with a heat gun can assist in reducing the installation force required.
- Install the cable end overtop the bushing bottom half.
- Install the bushing top half overtop.
- Confirm everything is fully seated, then install the circlip in its designated groove. Radial positioning does not matter.
Notes
-
Verify compatibility before ordering. Reach out with questions as needed!