P80 Volvo Shifter Cable End Bushing Retrofit+Upgrade Kits

P80 Volvo Shifter Cable End Bushing Retrofit+Upgrade Kits

22 mm (-99 cables) / 1 (M56LK retrofit)
$19.99
Skip to product information
P80 Volvo Shifter Cable End Bushing Retrofit+Upgrade Kits

P80 Volvo Shifter Cable End Bushing Retrofit+Upgrade Kits

$19.99
Cable End Size
Number of Bushings

These bushings are designed to bridge the gap between shifter cables and transmission levers when retrofitting either 1) P2 M56LK or 2) P2 M66 transmissions into either A) -99 cabled or B) 00- cabled shifters/vehicles.

The ball end design provides an upgrade in shifting precision and responsiveness, replacing the pin over sloppy rubber bushing OE design.

See photos for compatible shift lever comparison.

Installation

  1. Clear a working area around your transmission lever(s).
  2. Unclip the shift cable end from the pin and pull up to remove.
  3. Remove the OEM bushing from the cable end. Be patient.
  4. Unbolt the pin on the lever.
  5. Bolt in the replacement ball end.
  6. Grease the ball with Super Lube PTFE grease or equivalent.
  7. Install the bushing bottom half overtop the ball end. Warming it up with a heat gun can assist in reducing the installation force required.
  8. Install the cable end overtop the bushing bottom half.
  9. Install the bushing top half overtop.
  10. Confirm everything is fully seated, then install the circlip in its designated groove. Radial positioning does not matter.

Notes

  • Verify compatibility before ordering. Reach out with questions as needed!

You may also like